Viper SRT-10 V10-8.4L (2008)
1. Install the seat back cushion and cover (4) onto the seat back frame.
2. Install new hog rings.
3. Lock j-straps at the bottom of the seat back
4. Install the seat belt pass through bezel and seat the locking tabs fully.
5. Install the seat back onto the recliners and install the bolts. Tighten the bolts to 28 Nm (21 ft. lbs.).
6. Complete seat back cover installation by zipping up the cover (4).
7. Install the seat in the vehicle See: Service and Repair/Seat/Seat - Installation.
WARNING: Do not connect the battery negative cable. Serious or fatal injury may result if the system test is not performed first. See:
Restraint Systems/Air Bag Systems/Testing and Inspection
8. Place battery access cover into place and install four bolts.
9. Close deck lid.
