Viper SRT-10 V10-8.4L (2008)
Seat Cushion: Service and Repair
Seat Cushion Cover - Removal
REMOVAL
1. Open deck lid.
2. Remove four bolts to battery compartment cover and remove cover.
3. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components. Failure to do this
may result in serious or fatal injury.
4. Move seat as needed to access seat (1) attaching front bolts and rear nuts.
5. Remove the seat back See: Seat Back/Service and Repair/Seat Back/Seat Back - Removal.
6. Remove the seat adjuster See: Service and Repair/Adjuster-Seat/Removal.
7. Un-clip the j-straps on the cushion cover and then remove from cushion frame.
