Viper SRT-10 V10-8.4L (2008)
Front Door Weatherstrip: Service and Repair
Door Opening Primary Seal Weatherstrip
Removal
REMOVAL
1. Using a trim stick C-4755 or equivalent, remove the scuff plate.
2. Open the convertible top.
3. Remove the screw and push pin fasteners at the top of the seal.
4. Peal seal off of the door opening flange.
Installation
INSTALLATION
1. Position the seal to the bottom of the door opening, with bulb facing outboard, and install the rear screw and push pin fasteners.
2. Insert the tip of the seal into the a-pillar weatherstrip and insure the seat butt together tightly.
3. Press the seal onto the sill flange and work around the perimeter of the door opening until fully seated.
4. Install the door scuff plate and seat the spring clips fully.