Viper SRT-10 V10-8.4L (2008)
3. From inboard side, slide upper brake pad support pin (2) through caliper (3) and upper holes in both brake pads (1). Ensure that small end of
support pin is in hole (4) in outboard half of caliper.
4. Install upper end of brake pad spring clip (2) under upper brake pad support pin (1).
5. Press on lower end of spring clip (5) until it touches brake rotor.
6. Slide lower brake pad support pin (2) through caliper (1) and lower holes in both brake pads (3) in the same manner the upper pin was installed.
Ensure small end of support pin is in hole (4) in outboard half of caliper.
7. Release the spring clip allowing it to engage lower support pin.
