Viper SRT-10 V10-8.4L (2008)
b. Push wrench onto retainer until retainer fingers are collapsed.
c. Push on end of parking brake cable housing, pushing it through wrench and out of vehicle body.
8. Raise and support vehicle. See: Maintenance
9. Remove tire and wheel assembly from vehicle. See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and
Wheels - Removal
10. Unclip ABS wheel speed sensor from parking brake cable.
11. Grasp parking brake cable (1) between pivot wheel and apply lever, then pull outward until enough slack is present to remove cable from pivot
wheel.
12. Remove cable end from apply lever on caliper.
13. Remove cable from caliper bracket (2) holding cable housing (1).
14. Remove screws (2) from three cable routing clamps.
15. Remove parking brake cable (1).