Viper SRT-10 V10-8.4L (2008)
Keep hands out of automatic adjuster sector and pawl area. Failure to observe caution in handling this mechanism could lead to serious injury.
11. Ensure that parking brake cables are correctly installed on equalizer and aligned with cable track on parking brake lever.
12. Keeping hands clear of automatic adjuster sector and pawl area, firmly grasp screwdriver (pin punch or locking pin if a new lever has been
installed) (1) installed in lever mechanism, then quickly remove it from parking brake lever (2) mechanism. This action allows parking brake lever
mechanism to automatically take up any slack.
13. Cycle parking brake lever (2) once to position parking brake cables, then return lever its released position.
14. Check rear wheels of vehicle. They should rotate freely without dragging with lever in released position.
15. Fully apply parking brake lever.
16. Check rear wheels of vehicle. They should not rotate with lever in full-applied position.
17. Lower vehicle.
18. Install center console. See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Center Console - Installation
19. Remove blocks from tire and wheel assemblies.
