Viper SRT-10 V10-8.4L (2008)
9. Install camshaft phaser driveshaft (1) and rotate counter clockwise so the slot is in the 12 O'clock position.
10. Verify that the slot is in the 12 O'clock position (1).
11. Install camshaft drive plate/cover (1) and outer retaining bolts (2).
12. Tighten bolts to 12 Nm (106 in. lbs.) in the sequence shown.
NOTE: Place a block of wood between the crankshaft counter weight and engine block to stop engine from rotating while tighten bolt.
13. Install camshaft drive plate/cover center retaining bolt (1) and tighten to 65 Nm (48 ft. lbs.).
