Viper SRT-10 V10-8.4L (2008)
12. Tighten main bearing cap side bolts 1-12 to 27 Nm (20 ft. lbs.) in the sequence shown.
13. Tighten main bearing cap side bolts 1-12 to 54 Nm (40 ft. lbs.) in the sequence shown.
14. Remove the crankshaft holding tool.
15. Install new connecting rod bearings.
16. Install rod caps. Bolt threads should be coated with clean engine oil. Tighten connecting rod bolts to 45 Nm (33 ft. lbs.) +45°.
17. Install oil pump pick up tube using a new o-ring. Tighten 1/4-20 bolt to 11 Nm (95 in. lbs.). Tighten 5/16-18 nut to 23 Nm (200 in. lbs.).
18. Install the crankshaft rear oil seal retainer (2)See: Seals and Gaskets/Crankshaft Main Bearing Seal/Service and Repair/Rear Crankshaft Oil Seal
and Retainer - Installation.
19. Tighten rear seal adapter retaining bolts to 11 Nm (95 in. lbs.) in the sequence shown.
20. Install timing chain See: Timing Components/Timing Chain/Service and Repair/Timing Chain & Sprockets - Installation.
