Viper SRT-10 V10-8.4L (2008)
Marker Lamp: Service and Repair
Marker Lamp - Installation
Front Marker Lamp
INSTALLATION
1. Place marker lamp into socket and install in rear of headlamp unit. turn 1/4 turn clockwise until stops.
2. Install the front fender extension splash shield (3) on the respective side by and the fasteners (2).
3. Connect the battery negative cable.
4. Place battery access cover into place and install four bolts.
5. Close deck lid.
Rear Marker Lamp - Roadster
ROADSTER
1. Reach in behind the tail lamp unit and place lamp in socket, put in lamp unit opening and turn the lamp socket clockwise until it locks into place.
2. Install the two Torx head retaining screws to the access panel of the respective side of the vehicle.
3. Close deck lid.
Rear Marker Lamp - Coupe
COUPE
1. Position the lamp unit (2) in the rear quarter panel.
2. Install the one stamped nut (2).