Viper SRT-10 V10-8.4L (2008)
Knock Sensor: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate negative battery cable at battery.
2. Remove the intake manifold. See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Removal and Replacement/Intake
Manifold - Removal
3. Disconnect the knock sensors electrical connectors (3) and (4).
NOTE: Mark the orientation of the knock sensors prior to removal.
4. Remove the knock sensors mounting bolts (1).
5. Remove the knock sensors (2) from the engine block (3).