Viper SRT-10 V10-8.4L (2008)
Evaporative Emission Control Canister: Service and Repair
Vapor Canister - Installation
INSTALLATION
1. Install pump to bracket and tighten screws to 1.2 Nm (10.6 in. lbs.).
2. Before installing hoses to LDP, make sure they are not cracked or split. If a hose leaks, it will cause the Check Engine Lamp to illuminate.
Connect lines to the LDP.
3. Install the EVAP canister.
4. Install the liquid separator to the canister.
5. Install electrical connector to pump and push locking tab to lock.
6. Install the access panel.
7. Connect the negative battery cable, tighten the nut to 10 Nm (90 in. lbs.).
8. Use the scan tool, verify proper operation of LDP.