Viper SRT-10 V10-8.4L (2008)
Knock Sensor: Service and Repair
Installation
INSTALLATION
CAUTION: Hand start the bolt to prevent damage from cross-threading.
1. Install the knock sensors (2) to the engine block (3).
2. Install the knock sensor bolts (1) and tighten bolts to 15 Nm (11 ft. lbs.).
3. Connect the knock sensor electrical connectors (3) and (4).
4. Install the intake manifold. See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Removal and Replacement/Intake
Manifold - Installation
5. Connect the negative battery cable, tighten the nut to 10 Nm (90 in. lbs.).