Viper SRT-10 V10-8.4L (2008)
Seat Sensor/Switch: Description and Operation
Description
DESCRIPTION
The Seat Belt Switch is a Hall Effect-type sensor. This sensor consists of a fixed-position, Hall Effect Integrated Circuit (IC) chip and a small permanent
magnet that is integral to the left seat belt buckle. The seat belt buckles are located on a stamped steel stanchion within a molded plastic scabbard and
secured with a bolt to the inner side of the seat cushion frame. The seat belt switch is connected to the vehicle electrical system through a two-lead pigtail
wire and connector on the left seat belt buckle, which is connected to a wire harness connector in the body wire harness. A radio noise suppression
capacitor is connected in parallel with the IC where the two pigtail wire leads connect to the IC pins.
The seat belt switch cannot be adjusted or repaired and, if faulty or damaged, the entire seat belt buckle must be replaced.
