Viper SRT-10 V10-8.4L (2008)
11. Mount inclinometers (2) to both front Caster Angle Adapters, Special Tool 8995. Make sure inclinometer from left side of Switch Box is mounted
to left adapter and inclinometer from right side of Switch Box is mounted to right adapter. Adapters are marked Left and Right. To make sure each
inclinometer is mounted right-side-up on Adapter, upper mounting screw is larger diameter than lower.
12. Clean any dirt or debris off knuckles paying special attention to caster pads on leading end of knuckles near ball joints.
CAUTION: Be sure caster pads on knuckles are thoroughly cleaned before mounting Caster Adapters to knuckles. Caster Adapters must
sit flat on caster pads to obtain accurate caster readings.
13. Insert each Adapter (5) (with inclinometer (4) attached) through opening between upper control arm and tie rod. Position Adapter lower
spring-loaded hook (3) around lower ball joint nut and upper spring-loaded hook (1) over top of knuckle, then stretch bracket forward, placing
Adapter flats against caster pads cast into leading side of knuckle. Make sure step built into Adapter upper flat is placed against outside of upper
caster pad as shown and not on face of caster pad.
14. Adjust caster using measurements viewed on scan tool screen, and camber using measurements viewed on wheel alignment equipment. See:
Specifications
15. When adjustments are complete, remove Caster Adapters/Inclinometers.
INCLINOMETER INSTALLATION ON REAR KNUCKLES
16. Clean any dirt or debris off knuckles paying special attention to caster pads on trailing end of knuckles near ball joints.
NOTE: Do not attach Inclinometers to rear Adapters before Adapter installation on vehicle. If attached, they cannot be installed or removed
