Viper SRT-10 V10-8.4L (2008)
9. Install toe link (2) into mounting hole on knuckle (3). Install NEW nut on toe link stud and tighten to 75 Nm (55 ft. lbs.).
10. Install plastic appearance cap on toe link stud.
11. Tighten lower ball joint castle nut to 160 Nm (118 ft. lbs.).
12. Install cotter pin in end of lower ball joint stud.
13. Install ABS wheel speed sensor head (2) on knuckle. Install bolt (1) fastening speed sensor head to knuckle and tighten to 11 Nm (100 in. lbs.).
14. Install washer (7) and hub nut (6) on halfshaft yoke. Do not tighten at this time.
15. Install brake rotor, parking brake caliper and hydraulic brake caliper on knuckle. See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Brake Rotor - Installation
