Viper SRT-10 V10-8.4L (2008)
Stabilizer Bushing: Service and Repair
Front Stabilizer Bar Bushings - Installation
INSTALLATION
1. Thoroughly clean stabilizer bar in area of bushing contact. Install each NEW bushing on stabilizer bar by opening slit in bushing and wrapping it
around stabilizer bar, positioning it against retainer ring on bar.
2. Slide bushing retainers over bushings.
3. Install stabilizer bar assembly (3) back into vehicle in reverse order of removal through wheel opening.
4. Position bushing retainers against frame rails, then install four retainer bolts. Tighten four stabilizer bar bushing retainer bolts to 68 Nm (50 ft.
lbs.).
5. Lower vehicle.
