Viper SRT-10 V10-8.4L (2008)
Wheel Bearing: Service and Repair
Rear Hub / Bearing - Installation
INSTALLATION
CAUTION: A corrosion prevention gasket (1) is used between the hub and bearing and the knuckle. The gasket is required to prevent galvanic
corrosion between the hub and bearing and the knuckle.
1. Install NEW corrosion prevention gasket (1) on hub and bearing (2) before installation.
2. Install hub and bearing on knuckle. Align holes in hub and bearing and corrosion gasket with holes in knuckle.
3. Install four hub and bearing mounting bolts. Tighten bolts to 149 Nm (110 ft. lbs.).
4. Pull outward on lower end of knuckle and slide halfshaft yoke into rear of hub and bearing assembly.
5. Install lower ball joint into lower control arm (9). Install ball joint castle nut, but do not tighten at this time.
6. Install toe link (2) into mounting hole on knuckle (3). Install NEW nut on toe link stud and tighten to 75 Nm (55 ft. lbs.).
7. Install plastic appearance cap on toe link stud.
