Viper SRT-10 V10-8.4L (2008)
9. Release toe link (2) from knuckle using Puller (1), Special Tool C-4150A.
10. Remove cotter pin and castle nut from lower ball joint stud.
CAUTION: Do not strike or apply heat to steering knuckle in an effort to separate ball joint studs from knuckle.
NOTE: Use of Spacer, Special Tool 6983, is necessary to allow proper use of Puller, Special Tool C-4150A, to release lower ball joint from
lower control arm.
11. Insert Spacer (1), Special Tool 6983, between lower ball joint grease seal boot and lower control arm (4). Push Spacer in until it surrounds ball
joint stud. Use care not to damage grease seal boot.
CAUTION: When releasing ball joint using Puller, Special Tool C-4150A, use care not to pinch and damage ball joint grease seal boot.
12. Install Puller (2), Special Tool C-4150A, over Spacer and lower control arm as shown. Ball bearing in bolt of Special Tool C-4150A must be
centered in end of lower ball joint stud.
13. Release lower ball joint (3) from lower control arm using Puller. Remove tools. Lift ball joint stud from lower control arm.
14. Install Puller (2), Special Tool CT-1003, on hub and bearing flange (1).
