Viper SRT-10 V10-8.4L (2008)
Clutch Pedal Position Sensor / Switch: Service and Repair
Installation
INSTALLATION
1. Position plunger inside the switch (1) on the narrow section of the clutch master cylinder (2) actuation rod.
2. Place the top of the switch against the rod, then push the switch up slightly. This will compress the plunger.
3. Push the bottom of the switch against the rod.
CAUTION: Failure to follow these instruction will result in forcing the switch onto the rod and cracking the switch.
4. Install new white plastic retaining clip.
5. Install clutch master cylinder in vehicle.
6. Test clutch position switch operation.
