Viper SRT-10 V10-8.4L (2008)
8. Tighten lower ball joint castle nut to 160 Nm (118 ft. lbs.).
9. Install cotter pin in end of lower ball joint stud.
10. Install ABS wheel speed sensor head (2) on knuckle. Install bolt (1) fastening speed sensor head to knuckle and tighten to 11 Nm (100 in. lbs.).
11. Install washer (7) and hub nut (6) on halfshaft yoke. Do not tighten at this time.
12. Install brake rotor, parking brake caliper and hydraulic brake caliper on knuckle. See: Brakes and Traction Control/Disc Brake System/Brake
Rotor/Disc/Service and Repair/Removal and Replacement/Brake Rotor - Installation
13. Lower vehicle just enough to gain access to interior. Do not lower completely at this time.
14. Apply brakes several times to seat brake shoes and actuate parking brake lever several times to equalize parking brake adjustment.
15. Apply parking brake to keep halfshaft from rotating while tightening hub nut.
