Viper SRT-10 V10-8.4L (2008)
Shift Solenoid: Description and Operation
Solenoid-Skip Shift
Description
DESCRIPTION
The skip shift solenoid (1) prevents the operator from shifting into second or third gear during part throttle operation. The solenoid is threaded into the
left side of the transmission case.
Operation
OPERATION
The PCM controls the skip shift solenoid, locking out second and third gear when all of the following conditions are met:
-
Engine coolant exceeds 41°C (106°F)
-
Vehicle speed is between 12 and 20 MPH
-
Engine operating above 1322 RPM
-
The PCM verified first gear speed/RPM
-
Throttle position sensor (TPS) signal is less than 0.68 volt above closed throttle (23 percent throttle opening)
The solenoid resets when vehicle speed drops below 3 MPH.