W100 1/2 Ton Pickup 4WD V8-360 5.9L VIN 1 4-bbl (1988)
FIGURE 5
4.
Coat the bare blade terminal (dark green wire) of the body wiring harness, PN 4362286, liberally with Mopar Multi-Purpose Grease, PN
4318063, and snap terminal into insulator located on engine side of wiring assembly, PN 4362804, as shown in Figures 3-C and 5.
NOTE:
INSULATORS SHOULD BE DISCONNECTED FROM STEP A.5. IF NOT, DISCONNECT FEMALE INSULATOR
FROM MALE INSULATOR PRIOR TO INSERTION OF TERMINAL, AND BE SURE THAT WIRE OF BODY
HARNESS MATES WITH SAME COLOR WIRE OF WIRING ASSEMBLY. RECONNECT INSULATORS.
D.Engine Compartment Fuel Reservoir/Filter Installation