Fuel System Vapor Lock - Fuel Pressure Regulator - Technical Service Bulletins
FIGURE 2A - TERMINAL END OF BULKHEAD CONNECTOR (INSTRUMENT PANEL SIDE)
1.
Remove instrument panel left lower trim panel.
2.
Insert two bare terminals from instrument panel overlay harness, PN 4362289, into the instrument panel side of the bulkhead connector
(Figure 2-A).
a.
Gray with black tracer wire into cavity #14.
b.
Dark green wire into cavity #13.
INSTRUMENT PANEL WIRING
3.
Secure bare eyelet ground terminal (white with black tracer wire) from instrument panel overlay harness, PN 4362289, with screw, PN
9414722, to the back of the brake bracket (Figure 2-B).
NOTE:
CERTAIN VEHICLES ARE ALREADY EQUIPPED WITH THE
GROUND SCREW. IF SO, DISCARD THE SUPPLIED SCREW.
FIGURE 2C - INSTRUMENT PANEL WIRING
