W350 1 Ton Pickup 4WD V8-360 5.9L VIN 1 4-bbl (1988)
FIGURE 1-A - ENGINE OVERLAY HARNESS
3.
Route and secure the engine overlay harness, PN 4362295, along the existing headlamp-to-dash main engine wiring harness from the
ignition coil to the bulkhead connector, using the existing wiring clips and four tie wraps, PN 6015756. Loop and tape excess wire of the
overlay harness as shown in Figure 1-A.
FIGURE 1-B - IGNITION COIL
4.
Install the bare eyelet terminal of the overlay harness to the negative terminal of the ignition coil as shown in Figure 1-B.
