W350 1 Ton Pickup 4WD V8-360 5.9L VIN 1 4-bbl (1988)
FIGURE 3-A
FIGURE 3-C
1.
Route the single (black) wire with eyelet terminal of body wiring harness, PN 4362286, to the rear of the vehicle through the existing hole in
the rail as shown in Figures 3-A and 3-B. Clip the wiring into the existing ring clips. Remove the existing ground screw and install both
eyelet (ground) terminals into the screw and torque to 95 inch pounds. Take up excess ground wire and install tie wrap, PN 6015756, as
shown in Figure 3-A.
2.
Route the dark green wire of the body wiring harness, PN 4362286, to the front of the vehicle by using the existing ring clips on the chassis
rail, and installing tie wraps, PN 6015756, as shown in Figure 3-B.
NOTE:
THE NUMBER OF TIE WRAPS WILL VARY WITH WHEEL BASE LENGTH.
