W350 1 Ton Pickup 4WD V8-360 5.9L VIN 1 4-bbl (1988)
FIGURE 2-F - FUEL HOSE ASSEMBLY - RAMCHARGER ONLY
NOTE:
ON RAMCHARGER MODELS ONLY, USE A TIE WRAP, PN 6015756, TO SECURE THE SUPPLY AND
RETURN HOSE ASSEMBLIES AS SHOWN IN FIGURE 2-F.
5.
Connect the fuel tank vent hose, using the clamp provided.
6.
Attach the black mold connector, which is the gauge circuit (light blue with tracer wire), to the black stud of the newly installed
gauge/pump unit assembly. Tape back the existing yellow mold connector (white wire), as it will no longer be used.
7.
Install the red mold connector (pump feed circuit - dark green wire) from the new body wiring harness, PN 4362286, onto the red stud of
the newly installed gauge/pump unit assembly. Attach the yellow mold blade connector (ground - black wire) of body wiring harness, PN
4362286, to the ground blade of the gauge/pump unit assembly. Set aside the rest of the body wiring harness, PN 4362286, to assure
wiring is not pinched when reinstalling fuel tank.
CAUTION: INCORRECT WIRING CONNECTIONS WIll CAUSE THE FUEL LEVEL UNIT AND/OR CLUSTER GAUGE TO
FAIL AND THE ELECTRIC FUEL PUMP TO BE INOPERATIVE.
8.
Reinstall fuel tank to original position.
CAUTION: CARE MUST BE USED TO ENSURE THAT THE HOSE ASSEMBLIES ARE NOT PINCHED DURING TANK
REINSTALLATION.
C.Body Wiring Harness, Pn 4362286
