W350 1 Ton Pickup 4WD V8-360 5.9L VIN W 4-bbl (1983)
Fig 8 Removing Or Installing Inboard Shoe
1. Install the shoe and lining assemblies. See Install Brake Shoe.
2. Connect hydraulic hose to brake line, torque to specifications.
3. Connect hydraulic hose to caliper (with new seal washers) and torque to specifications.
4. Remove brake pedal prop, fill master cylinder reservoir (to within 1/4 inch (6.25mm) of top of reservoir.
5. Open caliper, bleed screw and allow caliper to gravity fill with brake fluid.
-
Be sure all air bubbles have escaped.
-
Replenish brake fluid in master cylinder.
6. Bleed brakes.
WARNING: Do not move vehicle until a firm pedal has been obtained and master cylinder fluid level is correct.
