W350 1 Ton Pickup 4WD V8-360 5.9L VIN W 4-bbl (1983)
Fig 4 Removing And Installing Snap Ring
7. Remove hub cap. Using Tool C-4020, or equivalent, remove snap ring.
8. Remove flange nuts and lockwashers.
9. Remove drive flange and discard gasket.
Fig 5 Removing Or Installing Outer Lockout
10. Straighten tang on lock ring and using Tool DD-12414D or equivalent, remove outer locknut, lock ring, inner locknut and outer bearing.
11. Carefully slide hub and rotor assembly from spindle.
Installation
Fig 5 Removing Or Installing Outer Lockout
NOTE: Whenever the disc and hub is removed for brake service the bearings should be cleaned, inspected and lubricated -- before assembly, as
follows.
