W350 1 Ton Pickup 4WD V8-360 5.9L VIN W 4-bbl (1983)
FIGURE 3-B - BODY WIRING HARNESS
D.
Body Wiring Harness PN 4362286
1.
Route the single wire with eyelet terminal of body wiring harness, PN 4362286, to the rear of the vehicle through the existing hole in the
rail (Figures 3-A and 3-B). Clip the wiring into the existing ring clips. Remove the ground screw and install both eyelet (ground) terminals
into the screw and torque to 95 inch pounds. Take up excess ground wire and tie wrap as shown in Figure 3-A.
2.
Route the dark green wire of harness, PN 4362286 (in-loom), to the front of the vehicle. Use the existing ring clips on the chassis rail. Tie
wrap the harness as shown in Figure 3-B.
NOTE:
THE NUMBER OF TIE WRAPS WILL VARY WITH WHEEL BASE LENGTH.
