W350 1 Ton Pickup 4WD V8-360 5.9L VIN W 4-bbl (1983)
11. Install spindle, brake adapter and splash shield. Install and torque nuts to 50-70 ft-lbs.
12. Place inner brake pad on adapter.
Fig. 19 Removing snap ring. 60 Front Axle
13. Install hub and rotor assembly onto spindle. Install outer bearing and inner locknut. Using tool DD-1241-JD and tool C-3952, torque locknut to 50
ft-lbs, to seat bearings. Then, back off locknut and retorque to 30-40 ft-lbs, while rotating hub and rotor. Back off nut 135 to 150 degrees.
Assemble lock ring and outer locknut. Torque locknut to 65 ft-lbs, minimum. Bend one tang of lock ring over inner locknut and another tang over
outer locknut. Bearing endplay should be 0.001-0.010 inch.
14. Install new gasket on hub, then the drive flange, lock washers and nuts. Torque nuts to 30-40 ft-lbs. Install snap ring and hub cap, or locking hub,
if equipped.
15. Position caliper on adapter and torque Allen screw to 12-18 ft-lbs.
16. Install wheel and lower vehicle.
17. Remove block from brake pedal.
