W 100 Pickup L6-225 3.7L (1984)
10.
Install the actuating cylinder by inserting it in the mounting bracket and lock in place by twisting it clockwise (Figure 6).
11.
Place the actuating cylinder push rod on the clutch pedal and install the circlip.
NOTE: DO NOT ATTEMPT TO REMOVE THE WHITE PLASTIC PUSH ROD RETAINER. DO NOT DEPRESS THE CLUTCH
PEDAL AT THIS TIME.
12.
Install the reservoir on the reservoir mounting bracket. Torque the screws to 95 inch pounds.
FIGURE 1
13.
Position the slave cylinder so that it can be installed from under the vehicle. Route and clip the tubing as shown in Figure 1.
FIGURE 7
14.
Install heat shield on exhaust pipe as shown in Figure 7.
Raise Vehicle, A-833 & A-435 Transmissions
Raise Vehicle
