W 150 Pickup V8-318 5.2L (1987)
FIGURE 4-B - FUEL RESERVOIR/FILTER INSTALLATION
2.
Install supplied fuel reservoir/filter, PN 4418012, using two (2) self-tapping screws, PN 6022777 (Figure 4-B). Screws must be tightened to
95 +/- 105 inch pounds.
3.
Remove and discard the fuel pump outlet tube, return hose, and fuel filter with rubber hoses and clamps. Install the fuel pump-toreservoir
tube (PN 4306968 for 4 x 4 or 4306967 for 4 x 2).
4.
On 4 x 2 Models
a.
Shorten 1/4" x 10" return hose and convolute sleeve assembly, PN 4418005, to 8". Remove convolute and shorten 1". Reinstall on hose.
b.
Install modified return hose assembly, PN 4418005, from the fuel reservoir return nipple to the chassis tube (Figure 4-B), and clamp
with PN 6500651 at each end.
c.
Shorten both 5/16" x 8" hoses, PN 4203576. One to 7", the other to 6".
d.
Shorten both 6" convolute sleeves, PN 4279993. One to 5", the other to 4".
e.
Slide the shortened 5" convolute, PN 4279993, over the shortened 7" hose, PN 4203576, and install from the reservoir outlet nipple to
the carburetor fuel tube (Figure 4-B). Clamp with PN 6500651 at each end.
CAUTION: BE SURE TO ROUTE THIS HOSE AND SLEEVE ASSEMBLY UNDER THE 8" RESERVOIR RETURN HOSE
