W 150 Pickup V8-360 5.9L (1984)
Fig 1 Disc Brake Assembly (Rear View)
NOTE: The inboard shoe anti-rattle spring must always be installed on top of the retainer spring plate.
6. Pump brake pedal several times until a firm pedal has been obtained.
7. Check and refill master cylinder reservoirs (if necessary) with DOT 3 brake fluid as required.
NOTE: It should not be necessary to bleed the system after shoe and lining removal and installation. However, if a firm pedal cannot be obtained
bleed the brake system.
8. Install wheel and tire assemblies and wheel covers.
9. Remove jack stands or lower hoist.
