W 150 Pickup V8-360 5.9L VIN W (1987)
Fig 5 Removing Or Installing Caliper
Removal & Inspection
1. Remove locking hub assembly, if equipped.
2. Raise and support vehicle, then remove wheel assembly.
3. Remove caliper retainer and anti-rattle assemblies.
4. Remove caliper from disc and support caliper to prevent damage to brake line.
5. Remove inboard brake shoe.
6. Remove grease cap and driving hub snap ring, then the driving hub and retaining spring.
7. On all models, remove wheel bearing adjusting locknut using tool C-4170 or equivalent, then the washer and adjusting nut.
8. Remove rotor assembly. The outer wheel bearing and retainer spring plate will slide out as rotor is removed.
9. Pry inner wheel bearing grease seal from hub, then remove bearing cone and the inner and outer bearing cups.
With Full Time 4WD
Fig. 9 Installing seal slinger on outer axle shaft. 44 FBJ Units w/disc brakes. Models w/full time 4WD
Fig. 10 Installing lip seal on outer axle shaft. 44 FBJ Units w/disc brakes. Models w/full time 4WD
