W 150 Ramcharger V8-360 5.9L (1991)
Band: Adjustments
A727/A904/A998/A999 3-Speed
Kickdown Band
Fig. 24 Kickdown band adjusting screw location
The kickdown band adjusting screw is located on left side of transmission case, Fig. 24.
1.
Raise and support vehicle, then loosen adjusting screw locknut and back off nut approximately 5 turns.
2.
Turn adjusting screw and check for binding. If screw binds, lubricate threads as required.
3.
Torque adjusting screw to 72 inch lbs. on 1987-88 vehicles or 47-50 inch lbs. on 1989-92 vehicles, then back off adjusting screw 2 1/2 turns.
4.
While holding adjusting screw in position, torque locknut to 30 ft-lbs, on all Chrysler vehicles and 1989-92 Jeep vehicles or 35 ft-lbs, on 1987-88
Jeep vehicles.
Low Reverse Band
Fig. 25 Low-reverse band adjusting screw location
1.
Raise vehicle, drain transmission and remove oil pan.
2.
Loosen adjusting screw locknut and back off nut approximately five turns, Fig. 25. Check adjusting screw for free turning in lever.
3.
Using an inch-pound torque wrench, torque band adjusting screw to 72 inch lbs.
4.
Back off adjusting screw 2 turns on A-727 transmission models or 4 turns on A-904, A-998 and A-999 transmission models.
5.
Hold adjusting screw in place and torque locknut to specifications.
6.
Install oil pan and add transmission fluid.
