W 250 Pickup L6-359 5.9L DSL (1989)
10. Carefully position caliper onto adaptor.
-
Position adaptor lock and spring between caliper and adaptor and tap into position.
Fig 2 Removing Or Installing (Allen Head) Key Retaining Screw
11. Install allen screw and tighten to 15 ft lb (20 Nm).
12. Install wheel and tire assembly. Tighten nuts to specified torque.
13. Lubricate at all fittings. Remove jack stands, lower vehicle, remove block from brake pedal and test vehicle operation.
For additional information see Fundamentals and Basics. See: Fundamentals and Basics
With Full Time 4WD
Fig. 9 Installing seal slinger on outer axle shaft. 44 FBJ Units w/disc brakes. Models w/full time 4WD
Fig. 10 Installing lip seal on outer axle shaft. 44 FBJ Units w/disc brakes. Models w/full time 4WD