W 250 Pickup L6-359 5.9L DSL (1989)
Cruise Control Servo Cable: Service and Repair
1. Remove hairpin clip and washer retaining cables to bellcrank.
2. Remove servo throttle cable from bellcrank.
3. Disconnect cable from servo, then remove cable assembly.
4. To install, insert servo stud through servo mounting bracket.
5. Connect cable sleeve to servo stud, align holes, then install hairpin clip.
6. Insert servo studs through holes in cable, then install new push nuts on servo studs.
7. Insert servo studs through holes in bracket, then install nut washers and torque to 4 ft. lbs.
8. Route cable from servo to cable support bracket.
9. Install cable end on bellcrank rod, then the washer and hairpin clip on end of bellcrank rod.
