W 250 Pickup L6-359 5.9L DSL (1989)
Crankshaft: Service and Repair
Removal and Installation
REMOVAL
^
Remove the rear crankshaft seal housing.
^
Remove the gear housing.
Rotate the engine to a horizontal position and remove the main bearing cap capscrews.
The main caps should be numbered. If they are not, be sure to mark them, beginning with number one at the front and ending with number seven at
the rear.
CAUTION: Do not pry on the main caps to free them from the cylinder block.
Use two of the main cap bolts to "wiggle" the main cap loose, being careful not to damage the bolt threads. Remove the caps.
