W 250 Pickup L6-359 5.9L DSL (1989)
Assemble the rear seal housing and gasket to the cylinder block with the capscrews.
Align the seal housing to the crankshaft with the alignment tool provided in the seal kit. Make sure the seal housing is level with both sides of the
block oil pan rail. Tighten the capscrews.
Torque Value: 9 N-m [7 ft-lbs]
Remove the alignment tool and trim the gasket even with the oil pan mounting surface.
REAR CRANKSHAFT SEAL - INSTALLATION
Seal O.D. Lubrication/Sealant
^
Rubber O.D. rear crankshaft seals are lubricated with soapy water.
^
Seals without rubber O.D. use Loctite 277, 11264 or No. 2654422 Sealant.
