W 250 Pickup L6-359 5.9L DSL (1989)
CAUTION: Make sure the dowel rings In the pedestals are Installed Into the dowel bores in the cylinder head.
NOTE: If the push rod is holding the pedestal off of the cylinder head, bar the engine until the pedestal will set on the head surface without
interference.
Use clean engine oil to lubricate the threads and under the heads of the 8mm and 12mm capscrews.
Install the capscrews into the pedestals.
Use the sequence shown to tighten ALL of the 12mm cylinder head capscrews.
Torque Value:
Step 1 - 40 N.m [29 ft-lbs]
Step 2 - 85 N-m [62 ft-lbs]
Step 3 - 126 N-m [93 ft-lbs]
