W 250 Pickup L6-359 5.9L DSL (1989)
Figure 1
Figure 2
NOTE:
WHEN INSTALLING THE SHIFT LEVER TO THE STUB SHIFTER DURING THIS PROCEDURE, IT IS IMPORTANT THAT
THE LEVER BE PROPERLY TIGHTENED TO THE
SPECIFIED TORQUE
--- 41 N-M (30 ft.lbs.).
REPAIR PROCEDURE
1.
Remove outer and inner shift boots (Figure 1) from floor pan.
2.
Loosen shift tower boot clamp and remove boot (Figure 2).
3.
Make sure that transmission is in Neutral and remove snap ring from inside transmission shift tower (Figure 2).
4.
Remove transmission stub shifter and stub shifter seat by pulling straight upward.
