Concord L6-258 4.2L VIN C 2-bbl (1982)
Heater Core: Service and Repair
1. Disconnect battery ground cable, then drain about 2 qts. from cooling system.
2. Disconnect heater hoses and plug heater core tubes.
3. Remove blower motor and fan.
4. Remove housing attaching nut(s) from inside engine compartment.
5. Remove package tray if so equipped.
6. Disconnect wire connector at resistor.
7. On models with A/C, remove instrument panel bezel, outlet and duct.
8. Disconnect control cables from damper levers.
9. Remove right side windshield pillar molding and the instrument panel upper attaching screws and right side cap screw at the door hinge post.
10. Remove right side kick panel and heater housing attaching screws.
11. Pull the right side of the instrument panel slightly rearward and remove the housing.
12. Remove cover and screws attaching heater core to housing, then remove heater core from housing.
13. Reverse procedure to install.
