Concord L6-258 4.2L VIN C 2-bbl (1982)
Ignition Control Module: Technical Service Bulletins
Ignition System - Test Procedure Revision
9E035
MAY 1983
1983 JEEP
SIX-CYLINDER ENGINE
Attention: Workshop, Parts Department
IGNITION SYSTEM
Information
The Sensor Check and Control Unit Check diagnostic procedure, on pages 40 and 41 of Supplement No. 1 to the 1982 Jeep Technical Service Manual,
are incorrect. Steps 2, 4 and 6 of this procedure have been revised to show the correct ohmmeter and voltmeter test probe test points required with the
engine compartment wire harness connectors used in 1983 models.
SENSOR CHECK AND CONTROL UNIT CHECK