Eagle L4-150 2.5L (1983)
Push Rod: Service and Repair
Fig. 3 Rocker arm, bridge & pivot assembly. 4-150
1.
Remove rocker arm cover attaching screws, then remove rocker arm cover.
RTV sealant is used between rocker arm cover and cylinder head
mating surfaces. To avoid damaging rocker arm cover, do not pry cover upward until seal has been completely broken. When prying
cover upward, pry only in areas marked ``Pry Here,'' which are located near rocker arm cover bolt holes.
2.
Alternately loosen the rocker arm cap screws one turn at a time to prevent damage to bridge,
Fig. 3.
3.
After removing rocker arm cap screws, remove bridge, pivots, rocker arms and pushrods.
Tag all components so they can be reinstalled in the
same position as removed.
4.
Reverse procedure to install. When installing rocker arm cap screws, tighten each screw alternately and evenly approximately one turn at a time to
prevent damage to bridge.