Eagle L4-150 2.5L (1983)
Fig. 9 Rotary valve parts
5. With notch end of spool towards valve body, install spool, aligning spool notch with pin in stub shaft.
6. Because of the small clearance between spool and valve body, extreme care must be taken when assembling these parts. Push spool evenly and
slowly with a slight oscillating motion until spool reaches drive pin. Before pushing spool completely in, make sure dampener O-ring seal is evenly
distributed in spool groove. Slowly push spool completely in, with extreme care taken not to cut or pinch O-ring seal.
7. Slide spool spring over stub shaft and work spring into position.
Model 605 Rack Piston, Valve & Worm
Fig. 14 Valve & worm removed from rack. Model 605
Fig. 15 Valve & worm disassembled. Model 605
