Eagle L4-150 2.5L (1983)
Fig. 16 Spool valve assembly. Model 605
Fig. 23 Stub shaft installation. Model 605
Fig. 24 Installing valve & worm into rack. Model 605
ASSEMBLE
1. To assemble spool valve proceed as follows:
a. Install three Teflon & three O-ring seals on spool.
b. Lubricate spool with power steering fluid, then rotate spool while installing.
c. Install stub shaft into valve body. Notch must fully engage pin and cap must seat against shoulder.
2. Assemble worm shaft on valve. Install snap ring with "curved in end" on same side as access hole.
3. To install valve and worm in rack:
a. Install Teflon ring and O-ring seal.
b. Hold rack teeth and worm drive pin in position.
