Eagle L4-150 2.5L (1983)
Technical Service Bulletin # 265389
Date: 890206
Threadmaker, Bond All GEL & Sealant - Application & Use
Models
All Models
Subject
Mopar Threadmaker Bondall Gel, And Flowable Silicone Windshield And Glass Sealant - Application And Use Instructions
Index
MISCELLANEOUS
Date
February 6, 1989
No.
26-53-89
P-345
(C26-05)
Mopar Threadmaker
Three new Mopar adhesives and sealants are now available for service use. They are:
Mopar Threadmaker
PN 4467725
Mopar Bondall Gel
PN 4467709
Mopar Flowable Windshield and Glass Sealant
PN 4467708
This bulletin describes the proper application and use of these products.
Mopar Threadmaker
PN 4467725
Mopar Threadmaker is a two-part epoxy product that is used to restore damaged or stripped threads in certain applications. This material is designed to
repair stripped threads in noncritical areas. It is quick, easy, and requires no special tools. It is also easy to use in limited access areas where removal of a
component may be difficult.
INSTRUCTIONS FOR USE
1.
Thoroughly clean the area to be repaired with Mopar Brake and Carburetor Cleaner (PN 4318037 or equivalent).
2.
Apply release agent to the bolt threads.
3.
Mix thoroughly a 50-50 blend of the two-part epoxy.
4.
Place material into bolt hole and screw bolt into hole.
5.
Wipe off excess material and wait for 15 minutes.
6.
After 15 minutes, torque to normal specification.
NOTE:
TEMPERATURES BELOW 65~F MAY REQUIRE LONGER CURE TIME.
7.
If the application requires Mopar Lock-N-Seal or Stud-NBearing mount thread locking compounds, wait for the Threadmaker to cure 15 minutes.
Then, remove the bolt, apply the thread locking compound, and torque to specification.
SUGGESTED APPLICATIONS FOR MOPAR THREADMAKER
Head Lamp Trim Rings
Carburetor Cover Screws
