Medallion L4-2165cc 2.2L (1988)
provided tie straps.
10.
Install the provided protective hose over the two (2) fuel lines as shown in Figure 3.
11.
Secure the protective hose with two of the provided tie straps, place one near the top and one near the bottom of the hose.
12.
Slide the hose down until it rests on the clamps at the base of the fuel lines.
13.
Install the short end of the two (2) provided 900 formed heater core hoses on to the heater core nipples (Figure 4).
NOTE:
Both heater core hoses have the same hose diameter on both ends. The hose with the air bleed valve should be connected to the forward heater
core nipple.
14.
Install the supplied bypass valve on the two heater core hoses installed above (Figure 4). Tighten all four hose clamps securely.
NOTE:
The vacuum motor on the bypass valve will be oriented in the UP position when correctly installed.
15.
Reinstall the coolant bottle. Secure the bottle with the rubber retaining strap.
