Medallion L4-2165cc 2.2L (1988)
an automatic transaxle, an additional bleed screw is located in the oil cooler upper coolant hose.
3.
Refill the cooling system. Do not install the coolant bottle pressure cap.
CAUTION:
Do NOT overfill the coolant bottle above the "Maximum" level.
4.
Close each bleed screw when a continuous stream of coolant flows out of each screw.
CAUTION:
Do not open the bleed screws while the engine is running.
5.
With the air conditioning OFF, start the engine and run it at 1500 RPM for about four (4) minutes or until the upper radiator hose is warm to the
touch.
6.
Turn the engine off and add coolant to the coolant bottle as necessary.
CAUTION:
Do NOT overfill the coolant bottle above the "Maximum" level.
7.
Inspect the cooling system for leaks and repair as necessary.
8.
Open the cooling system bleed screws.
9.
Close each bleed screw when a continuous stream of coolant flows out of the screw.
CAUTION:
Do not open the bleed screws while the engine is running.
10.
Install the provided coolant bottle pressure cap. Run the engine for an additional ten (10) minutes or until the engine cooling fans turn on and cycle
off.
CAUTION:
Do not reuse the old coolant bottle pressure cap.
11.
Turn the engine off.
12.
Recheck cooling system for leaks. Check coolant level in the coolant bottle. Top off the bottle to the maximum (MAX) mark if necessary.
IMPORTANT:
It is essential that all air is bled from the cooling system to prevent the engine from overheating.
Completion Reporting and Reimbursement
Claims for vehicles which have been serviced must be submitted on the DIAL System. Claims submitted will be used by Chrysler to record recall service
completions and provide dealer payments.
Use the following labor operation number and time allowance:
Labor Operation
Time
Number
Allowance
Install heater core bypass valve and
07745182
0.9 hours
splash shield
Add the cost of the recall parts package plus applicable dealer allowance to your claim.
Note:
See the Warranty Administration Manual, Recall Claim Processing Section for complete recall claim processing instructions.
Parts Return and Vehicle Not Available
Parts Return
Not required.
Vehicle Not Available
If a vehicle is not available for service for a known reason, let us know by filling out the pre-addressed Vehicle Disposition Form portion of the Owner