Medallion L4-2165cc 2.2L (1988)
1. Thoroughly clean hub assembly.
Fig. 2 Rear wheel bearing installation
2. Using a suitable press and a section of pipe (A, approximately 2 inches/51 mm in diameter), press bearing (B) into hub assembly.
3. Install a new bearing retaining clip.
4. Lightly lubricate axle shaft and install axle shaft hub onto axle shaft.
5. Install and tighten a new axle shaft hub locknut.
6. Install brake drum and attaching screws.
7. Install plastic hub cover.
8. Install wheel(s).
9. Check brakes from proper operation.
10. Lower vehicle.
